カテゴリー: 産業用組込み向けパーツ

販売終了

X9DRW-iF

JAN/UPC:0672042093779
メーカー型番:MBD-X9DRW-IF-O
TEKWIND型番:SPM-MBD-X9DRW-IF-O/1Y

1. Dual socket R (LGA 2011) supports Intel® Xeon® processor E5-2600 and E5-2600 v2 family†
2. Intel® C602 chipset; QPI up to 8.0GT/s
3. Up to 1TB ECC DDR3, up to 1866MHz; 16x DIMM sockets
4. Riser card support:Left side - 1 (x32) PCI-E 3.0
5. Intel® i350 Dual port GbE LAN
6. 8x SATA2 and 2x SATA3 ports
7. Integrated IPMI 2.0 and KVM with Dedicated LAN
8. 6x USB 2.0 ports (4 rear + 2 via header)

この製品を問い合わせる


スペック

Product SKUs

MBD-X9DRW-iF -O X9DRW-iF (Standard Retail Pack)
MBD-X9DRW-iF -B X9DRW-iF (Bulk Pack)

Physical Stats

Form Factor Proprietary WIO
Dimensions 12" x 13" (30.5cm x 33.0cm)

Processor/Cache

CPU Dual Socket R (LGA 2011)
Intel® Xeon® processor E5-2600 
and E5-2600 v2 family† 
(up to 135W TDP **)
Note † BIOS version 3.0 or above is required
** Motherboard supports this maximum TDP. Please verify your system can thermally support.
Cache Up to 30MB
System Bus QPI up to 8 GT/s

System Memory

Memory Capacity 16x 240-pin DDR3 DIMM sockets
Up to 1TB DDR3 ECC LRDIMM
Up to 512GB DDR3 ECC RDIMM
Up to 128GB DDR3 ECC/non-ECC UDIMM
Memory Type 1866/1600/1333/1066/800MHz* ECC DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
Support ECC and non-ECC UDIMMs

* Maximum memory speed may be capped by CPU. Please verify that the chosen CPU can support desired memory speed.
DIMM Sizes 32GB, 16GB, 8GB, 4GB, 2GB, 1GB,
64GB LRDIMM
Memory Voltage 1.5 V, 1.35 V
Error Detection Corrects single-bit errors
Detects double-bit errors (using ECC memory)

On-Board Devices

Chipset Intel® C602 chipset
AHCI SATA SATA 2.0 3Gbps with RAID 0, 1, 5, 10
SATA 3.0 6Gbps with RAID 0, 1, 5, 10
SCU SATA SATA 2.0 3Gbps with RAID 0, 1, 5, 10
IPMI Support for Intelligent Platform Management Interface v.2.0
IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
Renesas SH7757 BMC
Network Controllers Intel® i350 Dual Port Gigabit Ethernet
Virtual Machine Device Queues reduce I/O overhead
Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
1x Realtek RTL8211E PHY (dedicated IPMI)
Video G200 (Renesas SH7757 BMC)

 Input / Output

AHCI SATA 2x SATA 3.0 ports (6Gbps)
4x SATA 2.0 ports (3Gbps)
SCU SATA 4x SATA 2.0 ports (3Gbps)
LAN 2 RJ45 Gigabit Ethernet LAN ports
1 RJ45 Dedicated IPMI LAN port
USB 6 USB 2.0 ports total
(4x rear + 2x via header)
Video 1 VGA port
Serial Port / Header 2 Fast UART 16550 ports / 1 rear and 1 header
DOM 1 DOM (Disk on Module) power connector

Chassis (Optimized for X9DRW-iF )

1U Chassis CSE-113TQ-600WB
CSE-113TQ-R700WB
CSE-116TQ-R700WB
CSE-815TQ-600WB
CSE-815TQ-R700WB
2U Chassis CSE-213A-R740WB
CSE-825TQ-R740WB
Important Chassis Notes To support the new generation Intel® Xeon® processor-based motherboards,Revision M chassis is recommended. Please talk to your sales representative for details.

SuperServer(s) with X9DRW-iF

Model(s) SYS-1027R-WRF
SYS-2027R-WRF
SYS-6017R-NTF
SYS-6017R-WRF
SYS-6027R-WRF

Expansion Slots

PCI-Express 1 PCI-E 3.0 (x32) left hand side
riser card support

(Both CPUs need to be installed for full access to PCI-E slots and onboard controllers. See manual block diagram for details.)

System BIOS

BIOS Type 128Mb SPI Flash EEPROM with AMI BIOS
BIOS Features Plug and Play (PnP)
APM 1.2
PCI 2.3
ACPI 1.0 / 2.0 / 3.0 / 4.0
BIOS rescue hot keys
USB Keyboard support
SMBIOS 2.7.1
UEFI 2.3.1

Management

Software SuperDoctor® III
Watch Dog
NMI
IPMI 1.5 / 2.0
Power Configurations ACPI / APM Power Management
Power-on mode for AC power recovery

PC Health Monitoring

Voltage Monitors for CPU Cores, +1.1V, +1.5V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby, VBAT, 4 Memory Voltages.
5+1 Phase-switching voltage regulator
FAN 6x 4-pin fan headers
6x fans with tachometer monitoring
Status monitor for speed control
Status monitor for on/off control
Low noise fan speed control
Pulse Width Modulated (PWM) fan connectors
Temperature Monitoring for CPU and chassis environment
CPU thermal trip support
Thermal Control for 6x Fan Connectors
Thermal Monitor 2 (TM2) support
PECI
LED CPU / System Overheat LED indicator
Suspend static indicator LED
UID/Remote UID
Other Features Chassis intrusion detection
Chassis intrusion header
SDDC Support
RoHS
Dual cooling zones

Operating Environment

Operating Temperature Range 10°C - 35°C (50°F - 95°F)
Non-Operating Temperature Range -40°C - 70°C (-40°F - 158°F)
Operating Relative Humidity Range 8% - 90% (non-condensing)
Non-Operating Relative Humidity Range 5% - 95% (non-condensing)

産業用組込み向けパーツに関連する導入事例

導入事例はありません。

産業用組込み向けパーツに関連する特集記事

特集記事はありません

(C) Tekwind Co., Ltd. ALL RIGHTS RESERVED.