・JAN/UPC：0672042053803
・メーカー型番：SYS-6026TT-HTRF_Rev2.0
・TEKWIND型番：SPM-SYS-6026TT-HTRF
Four hot-pluggable systems (nodes) in a 2U form factor. Each node supports the following:
1. Intel® Xeon® processor 5600/5500 series, with QPI up to 6.4 GT/s
2. Up to 192GB** DDR3 1333/ 1066/800MHz ECC Registered DIMM / 48GB
Unbuffered DIMM
3. 1 (x16) PCI-E ( Low Profile)
4. Integrated IPMI 2.0 with KVM and Dedicated LAN
5. Dual Intel® 82574L Gigabit Ethernet Controller
6. 3x Hot-swap SATA Drive Bays
7. 1400W Gold-level High-efficiency Redundant Power Supplies
製品についてお気軽にお問い合わせください
この製品を問い合わせる
スペック
Product SKUs
| SYS-6026TT-HTRF | SuperServer 6026TT-HTRF (Black) |
|---|
Motherboard
| 4x Super X8DTT-HF+ |
Processor/Cache
| CPU | Dual 1366-pin LGA Sockets Supports up to two Intel® 64-bit Xeon®processor(s) of the same type below: Intel® Xeon® Processor X5600/E5600/L5600 Series (Westmere) 40W - 95W Intel® Xeon® Processor X5500/E5500/L5500 Series (Nehalem-EP) 38W - 95W |
|---|---|
| QPI | up to 6.4 GT/s |
System Memory
| Memory Capacity | 12x 240-pin DIMM sockets Supports up to 192 GB** 1333 / 1066 / 800MHz DDR3 ECC Registered memory Supports up to 48 GB 1333 / 1066 / 800MHz DDR3 ECC / Non ECC Unbuffered memory Memory Mirroring supported |
|---|---|
| Memory Type | 1333 / 1066 / 800MHz ECC Registered / ECC or Non ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs |
| DIMM Sizes | 1GB, 2GB, 4GB , 8GB** , 16GB** |
| Memory Voltage | 1.5 V |
| Error Detection | Corrects single-bit errors Detects double-bit errors (using ECC memory) Supports Intel® x4 and x8 Single Device Data Correction (SDDC) |
On-Board Devices (per Node)
| Chipset | Intel® 5500 (Tylersburg) chipset ICH10R + IOH-36D |
|---|---|
| SATA | Intel ICH10R SATA 3.0Gbps Controller RAID 0, 1, 5, 10 support |
| IPMI | Support for Intelligent Platform Management Interface v.2.0 IPMI 2.0 with virtual media over LAN and KVM-over-LAN support Nuvoton WPCM450 BMC |
| Network Controllers | Dual Intel® 82574L Gigabit Ethernet Controller Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output 1x Realtek RTL8201N PHY (dedicated IPMI) |
| Graphics | Matrox G200eW |
| Super I/O | Winbond W83527HG chip |
| Clock Generator | 932S421 chip |
Input / Output (per Node)
| Serial ATA | Six Serial ATA ports 3 SATA hard drives supported |
|---|---|
| LAN | 2x RJ45 LAN ports 1x RJ45 Dedicated IPMI LAN port |
| USB | 2 rear + 1 header (2 Ports) 4 total USB ports, 2.0 Compliant / 1.1 Compliant |
| VGA | 1x VGA Port |
| Serial Port | 1 Fast UART 16550 serial port |
System BIOS (per Node)
| BIOS Type | 32Mb SPI Flash EEPROM with AMI® BIOS |
|---|---|
| BIOS Features | Plug and Play (PnP) PCI 2.2 ACPI up to 3.0 USB Keyboard support |
Chassis
| Form Factor | 2U Rackmount |
|---|---|
| Model | CSE-827H-R1400B |
Dimensions
| Height | 3.5" (89mm) |
|---|---|
| Width | 17.2" (437mm) |
| Depth | 28.5" (724mm) |
| Gross Weight | 85 lbs (38.6kg) |
| Available Colors | Black |
Front Panel (per Node)
| Buttons | Power On/Off button UID button |
|---|---|
| LEDs | Power LED (on power button) Network activity LED System Overheat/fan fail/power fail/ LED UID LED (on UID button) |
Expansion Slots (per Node)
| PCI-Express | 1 (x16) PCI-E ( Low Profile) |
|---|
Drive Bays (per Node)
| Hot-swap | 3x 3.5" SATA Hot-swap drive bays |
|---|
Hard drive Backplane
| 2U Hard drive Backplane |
System Cooling
| Fans | 4x Cooling Fans |
|---|
Power Supply
| 1400W high-efficiency (1+1) redundant power supply with PMBus | |
| AC Input | 1100W Output @ 100-140V, 13.5-9.5A, 50-60Hz 1400W Output @ 180-240V, 9.5-7.0A, 50-60Hz |
|---|---|
| DC Output | 1100W: +12V/92A; +5Vsb/4A 1400W: +12V/116A; +5Vsb/4A |
| With Distributor | +5V: 30 Amp +3.3V: 24 Amp -12V: 0.6 Amp |
| Certification |  Gold Certified [ Test Report ] |
PC Health Monitoring
| CPU | Monitors for CPU Cores,+1.5V, +3.3V, +5V, +12V, +5 Stdby, +3.3 Stdby, VBAT, Memory Voltages. CPU Core 6-Phase-switching voltage regulator |
|---|---|
| FAN | Total of four 4-pin PWM fans 4x fans with tachometer monitoring Status monitor for speed control Status monitor for on/off control Low noise fan speed control |
| Temperature | Monitoring for CPU and chassis environment CPU thermal trip support Thermal Control for 4x Fan Connectors PSU I2C temperature sensing logic Thermal Monitor 2 (TM2) support PECI |
| LED | Power Fail / Overheat LED Suspend-state Indicator LED UID LED |
| Other Features | SDDC Support |
Operating Environment / Compliance
| RoHS | RoHS Compliant |
|---|---|
| Environmental Spec. | Operating Temperature: 10°to 35°C (50°to 95°F) Non-operating Temperature: -40°to 70°C (-40°to 158°F) Operating Relative Humidity: 8% to 90% (non-condensing) Non-operating Relative Humidity: 5 to 95% (non-condensing) |
関連製品
サーバー・ワークステーション
TEKIPAKIサーバー A1
最大24コアCPUが選択可能なコンパクトラックマウントサーバーシステム。 様々なカスタマイズにも対応しており、ベースモデルは基本1台からご注文いただけます。
A+ Server AS -A126GS-TNBR
AI・HPC用途に最適な10U空冷ラックマウント型GPUサーバー。 AMD EPYC™ 9005/9004対応、最大8基のNVIDIA HGX B200を搭載。
SuperServer SYS-A22GA-NBRT
AI・HPC用途に最適な10U空冷ラックマウント型GPUサーバー。 Intel® Xeon® 6900 シリーズ対応、最大8基のNVIDIA HGX B200を搭載。
A+ Server AS -4126GS-NBR-LCC
AI・HPC用途に最適な4U液冷ラックマウント型GPUサーバー。 AMD EPYC™ 9005/9004 シリーズ対応、最大8基のNVIDIA HGX B200を搭載。
製品検索
