・JAN/UPC:0672042111213
・メーカー型番:MBD-X9DBL-IF-O
・TEKWIND型番:SPM-MBD-X9DBL-IF-O/1Y
1. Dual socket B2 (LGA 1356) supports Intel® Xeon® processor E5-2400 v2
2. Intel® C602 chipset
3. Up to 384GB DDR3 1600MHz LRDIMM / 192GB RDIMM; 6x DIMM sockets
4. Expansion slots: 1 PCI, 3 PCI-E 3.0 x8 1 PCI-E 3.0 x16, 1 PCI-E 3.0 x4 (in x8)
5. Intel® 82574L GbE LAN, 2 ports
6. 8x SATA2 and 2x SATA3 ports
7. Integrated IPMI 2.0 and KVM with Dedicated LAN
8. 7x USB 2.0 ports (2 rear, 4 via header + 1 Type A)
製品についてお気軽にお問い合わせください
この製品を問い合わせるスペック
Product SKUs
MBD-X9DBL-iF -O | X9DBL-iF (Standard Retail Pack) |
---|---|
MBD-X9DBL-iF -B | X9DBL-iF (Bulk Pack) |
Physical Stats
Dimensions | 12" x 10" (30.48cm x 25.4cm) |
---|
Processor/Cache
CPU | Intel® Xeon® processor E5-2400 and E5-2400 v2 (up to 95W TDP **) Dual Socket B2 (LGA 1356) |
---|---|
Cache | Up to 25MB |
System Bus | QPI up to 8 GT/s |
** Motherboard supports this maximum TDP. Please verify your system can thermally support |
System Memory
Memory Capacity | 6x 240-pin DDR3 DIMM sockets Up to 384GB DDR3 ECC LRDIMM Up to 192GB DDR3 ECC Registered memory (RDIMM) Up to 48GB DDR3 ECC/non-ECC Un-Buffered memory (UDIMM) |
---|---|
Memory Type | 1600/1333/1066/800MHz* ECC DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs Support ECC and non-ECC UDIMMs * Maximum memory speed may be capped by CPU. Please verify that the chosen CPU can support desired memory speed. |
DIMM Sizes | 32GB, 16GB, 8GB, 4GB, 2GB, 1GB |
Memory Voltage | 1.5 V, 1.35 V |
Error Detection | Corrects single-bit errors Detects double-bit errors (using ECC memory) |
On-Board Devices
Chipset | Intel® C602 chipset |
---|---|
AHCI SATA | SATA 2.0 3Gbps with RAID 0, 1, 5, 10 SATA 3.0 6Gbps with RAID 0, 1, 5, 10 |
SCU SATA | SATA 2.0 3Gbps with RAID 0, 1, 5, 10 |
IPMI | Support for Intelligent Platform Management Interface v.2.0 IPMI 2.0 with virtual media over LAN and KVM-over-LAN support Nuvoton WPCM450 BMC |
Network Controllers | Intel® 82574L Gigabit Ethernet Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output 1x Realtek RTL8201F PHY (dedicated IPMI) |
Video | Matrox G200eW |
Input / Output
AHCI SATA | 2x SATA 3.0 ports (6Gbps) 4x SATA 2.0 ports (3Gbps) |
---|---|
SCU SATA | 4x SATA 2.0 ports (3Gbps) |
LAN | 2x RJ45 Gigabit Ethernet LAN ports 1x RJ45 Dedicated IPMI LAN port |
USB | 7x USB 2.0 ports total (2 rear + 4 via header + 1 Type A) |
Video | 1x VGA port |
Serial Port / Header | 2x Fast UART 16550 ports / 1 rear and 1 header |
DOM | 1 DOM (Disk on Module) power connector |
Chassis (Optimized for X9DBL-iF )
1U Chassis | CSE-113MTQ-600CB CSE-813MTQ-350C CSE-813MTQ-441CB CSE-813MTQ-R400CB |
---|---|
2U Chassis | CSE-823TQ-653B |
3U Chassis | CSE-833T-653B |
Tower / 4U Rackmount | CSE-842TQ-665B CSE-842TQ-865B |
Important Chassis Notes | To support the new generation Intel® Xeon® processor-based motherboards,Revision M chassis is recommended. Please talk to your sales representative for details. |
SuperServer(s) with X9DBL-iF
Model(s) | SYS-1027B-MTF SYS-6017B-MTF SYS-6017B-MTLF SYS-6017B-MTRF SYS-6027B-TLF |
---|
Expansion Slots
PCI-Express | 1x PCI-E 3.0 x16 3x PCI-E 3.0 x8 1x PCI-E 3.0 x4 (in x8) 1x PCI-32 (Both CPUs need to be installed for full access to PCI-E slots and onboard controllers. See manual block diagram for details.) |
---|
System BIOS
BIOS Type | 64Mb SPI Flash EEPROM with AMI BIOS |
---|---|
BIOS Features | Plug and Play (PnP) APM 1.2 PCI 2.3 ACPI 1.0 / 2.0 / 3.0 / 4.0 USB Keyboard support SMBIOS 2.7.1 UEFI 2.3.1 |
Management
Software | SuperDoctor® III Watch Dog NMI IPMI 1.5 / 2.0 |
---|---|
Power Configurations | ACPI / APM Power Management Power-on mode for AC power recovery |
PC Health Monitoring
Voltage | Monitors for CPU Cores, +1.1V, +1.5V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby, VBAT, Memory Voltages. 5+1 Phase-switching voltage regulator |
---|---|
FAN | Six 4-pin fan headers with tachometer monitoring Status monitor for speed control Status monitor for on/off control Low noise fan speed control Pulse Width Modulated (PWM) fan connectors |
Temperature | Monitoring for CPU and chassis environment CPU thermal trip support Thermal Control for 6x Fan Connectors Thermal Monitor 2 (TM2) support PECI |
LED | CPU / System Overheat LED Suspend static indicator LED UID/Remote UID |
Other Features | Chassis intrusion detection Chassis intrusion header RoHS, Halogen Free Dual Cooling Zones |
Operating Environment
Operating Temperature Range | 10°C - 35°C (50°F - 95°F) |
---|---|
Non-Operating Temperature Range | -40°C - 70°C (-40°F - 158°F) |
Operating Relative Humidity Range | 8% - 90% (non-condensing) |
Non-Operating Relative Humidity Range | 5% - 95% (non-condensing) |
関連製品
産業用/組込み用パーツ
MTE720T ― NVMe PCIe Gen4のM.2産業用SSD
112層3D NANDフラッシュ、8チャンネルコントローラー、PCIe Gen 4 x4インターフェースを組み合わせたM.2 SSD。NVMe 1.4規格準拠で、高速なデータ転送スピードを実現しています。
MTE460T ー PCIe Gen3の産業用M.2 SSD
PCIe Gen3 x2インターフェースと112層3D NAND搭載の産業用M.2 SSD。30µ"厚の金端子PCB、コーナーボンド、耐硫化チップ抵抗を適用し、-20℃~75℃の幅広い動作温度で使用できる製品です。
MSA470T ― SATA Ⅲと112層3D NAND搭載で小型端末に最適なmSATAの産業用SSD
トランセンド MSA470Tは、SATA Ⅲインターフェース、112層3D NAND、様々な技術と機能を搭載した業務用・産業用・組込向けの省スペースのmSATA SSD。
MTS970T ― SATA Ⅲ 6Gb/sと112層3D NANDの産業用M.2 2280 SSD
トランセンド MTS970T M.2 SSDは、SATA-III 6Gb/sインターフェース、112層の3D NANDフラッシュを採用し、DRAMキャッシュ搭載で高速アクセスを可能とするSSD。